- PC + Linux + Bit3. Javier
made a Bit3 driver for Linux, so you can read/write on VME
transparently.
- SEQUENCER(ps). This VME module generates all
the command lines needed by the ABCD.
- DRAFT(pdf). This other module receives, decodes
and stores the DATA from the ABCD. It also provides used with the SEQSI
the control signals.
- PCB BOARD. The ABCD is connected on it, the board converts the
signals to the chip from ECL to LVDS, and the ones from the chip from
LVDS to ECL.
- Power Supply. It provides VEE and 5V to the ABCD Board, and also VDD
and VCC to the chip.
- DAQ Software. Carlos Lacasta wrote the DAQ program to obtain the
threshold scans.
- Analysis Software. A macro in ROOT provides the plots for
the Parameter Optimization and the Calibration.
- ABCD 1.
- BC96. It converts commands and clock to LVDS, and routes incomming data
to DRAFT. It provides the power supply VCC and VDD, so the external
power supply is not needed.
- Support Card. The hybrid is on a Melbourne SC3.2nd support
card.
- The Liverpool forward hybrid, version 1.
- DAQ Software. Carlos Lacasta wrote the DAQ program to obtain the
threshold scans.
- Analysis Software. A macro in ROOT provides the plots for
the Parameter Optimization and the Calibration.
| Type | Wafer ID | X | Y | Hybrid Position |
| N | 2 | 4 | 13 | M0 |